Premium 3D Printer Filament PLA 1.75 mm, 1KG Spool

PLA is a good choice for a printing material if you are looking for high accuracy and high resolution. It extrudes at lower temperatures, does not require a heated base, and has a very low shrinkage rate (0.3%). PLA is harder than ABS but is therefore also a bit more brittle. Additionally, PLA is a plant-based plastic, which means that it is biodegradable and gives off a slightly sweet odor, like roasting corn.

This 1 KG spool features a thickness of 1.75mm ±0.10mm, with a roundness variation of only 0.03mm. It has a nominal processing temperature of 190-230°C. Thickness and roundness factors are laser measured at the factory to ensure accuracy over the entire length of the filament.

The negatives of using PLA is that it is vulnerable to degradation from moisture, sunlight, and heat. Additionally, it is more prone to overheating during processing, which can cause dripping and be dropping if it gets too hot.

Features:

Made from a reliably strong material
Light weight
Accommodates a wide range of printing temperatures
Diameter is 1.75 mm
Individual spool has a weight of 1 kg
Compatible with a variety of 3D printers: Makerbot, UP Plus, Mendel, Prusa, Series...
No bubbling occurs when printing models